Rohde & Schwarz SMBV100A - Page 728

Remote Control Commands
R&S
®
SMBV100A
713Operating Manual 1176.8016.02 ─ 17
Example:
BB:MCCW:TRIG:OUTP2:PULS:DIV 4
sets the divider for the marker signal on output MARKER 2 to
the value 4.
BB:MCCW:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal
BB:MCCW:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency for the marker signal.
Response: "33 000"
the resulting pulse frequency is 33 kHz.
Usage: Query only
Manual operation: See "Marker Mode" on page 448
Clock Settings
[:SOURce<hw>]:BB:MCCW:CLOCk:MODE...................................................................... 713
[:SOURce<hw>]:BB:MCCW:CLOCk:MULTiplier................................................................ 713
[:SOURce<hw>]:BB:MCCW:CLOCk:SOURce................................................................... 714
[:SOURce<hw>]:BB:MCCW:CLOCk:SYNChronization:MODE............................................ 714
[:SOURce<hw>]:BB:MCCW:CLOCk:SYNChronization:EXECute.........................................715
[:SOURce<hw>]:BB:MCCW:CLOCk:MODE <Mode>
Sets the type of externally supplied clock (:BB:MCCW:CLOCk:SOURce EXTernal).
When MSAMple is used, a multiple of the sample clock is supplied via the CLOCK con-
nector and the sample clock is derived internally from this. The multiplier is entered
with the command BB:MCCW:CLOCk:MULTiplier.
Parameters:
<Mode> SAMPle | MSAMple
*RST: SAMPle
Example:
BB:MCCW:CLOC:MODE SAMP
selects clock type "Sample", i.e. the supplied clock is a sample
clock.
Manual operation: See "Clock Mode" on page 450
[:SOURce<hw>]:BB:MCCW:CLOCk:MULTiplier <Multiplier>
Specifies the multiplier for clock type Multiple Samples (:BB:MCCW:CLOCk:MODE
MSAM) in the case of an external clock source.
Parameters:
<Multiplier> integer
Range: 1 to 64
*RST: 4
SOURce Subsystem