Safran VersaSync - Page 407

Table 1-3: VersaSync inputs (default setup) 7
Table 1-4: VersaSync outputs (default setup) 8
Table 1-5: Power connector pinout 10
Table 1-6: Default I/O connector pinout 11
Table 1-7: Ethernet connector pinout 12
Table 1-8: Connector Part Numbers 14
Table 1-9: 10 MHz output — oscillator types and accuracies 19
Table 1-10: 10 MHz output — oscillator stability 20
Table 1-11: 10 MHz output — oscillator phase noise (dBc/Hz) 20
Table 1-12: 1PPS output accuracies 20
Table 2-1: Safety symbols used on this product or in this document 28
Table 2-2: Available signal types 45
Table 2-3: I/O signal mapping to Channels 46
Table 2-4: Signature control output-presence states 70
Table 2-5: Default IP addresses 74
Table 2-6: System Time Message format 108
Table 2-7: System Time Message field descriptions 108
Table 3-1: Reference priority titles 172
Table 3-2: Receiver dynamics, ~modes, ~ dynamics, ~ types 205
Table 3-3: Estimated Phase Drifts 221
Table 3-4: Typical Holdover lengths in seconds 222
Table 3-5: TFOM to ETE conversion 225
Table 4-1: Default and recommended configurations 299
Table 5-1: Troubleshooting using the Web UI Status indications 307
Table 5-2: Troubleshooting 1PPS and/or 10 MHz outputs not being present 310
Table 5-3: VNYPR Settings 322
Table 5-4: VNQTN Settings 323
Table 5-5: VNQMR 324
Table 5-6: VNMAG Settings 325
Table 5-7: VNACC Settings 326
Table 5-8: VNGYR Settings 326
Table 5-9: VNMAR Settings 327
Table 5-10: VNYMR Settings 328
Table 5-11: VNYBA Settings 329
Table 5-12: VNYIA Settings 330
Table 5-13: VNIMU Settings 331
Table 5-14: VNGPS Settings 332
Table 5-15: GPS Fix 332
Table 5-16: VNGPE Settings 333
Table 5-17: GPS Fix 334
Table 5-18: VNINS Settings 335
VersaSync User Manual 393
APPENDIX