SATO CL4NX Plus - Page 331

331
[Head] (SOS users only)
You can specify or check the print distance of the print head for the timing to perform the periodic
notification.
Appears only if you have selected [Head] or [Head+Cutter] for [Counter] in the [Type] menu.
The setting items are as follows:
Meters
Specifies the print distance of the print head for the timing to perform the periodic notification.
Last Update
Shows the print distance of the print head for the last periodic notification.
Next Update
Shows the print distance of the print head for the next periodic notification.
Current Value
Shows the current print distance of the print head.
[Meters] (SOS users only)
Specifies the print distance of the print head for the timing to perform the periodic notification. You will
be notified for every meter you specify.