208
To initialize a new SRAM card:
1.
Install the card.
2.
Press ON.
A message telling you this card needs to be
initialized will appear.
3.
Touch Initialize.
4.
Touch Yes to confirm.
To initialize a previously used SRAM card:
1.
Install the card.
2.
Hold down ON while pressing and releasing
the RESET switch.
3.
Touch No when prompted to clear the main
memory.
4.
Touch Yes when prompted to clear the card
memory.
Note that this will delete all data on the card.
To copy data to the SRAM card:
Note that although the data of the communications
applications (those applications found under
"TOOLS") will be copied to the SRAM card, it
cannot be accessed from there. This data will,
however, be copied back to the main memory if
you ever decide to copy all data back from the
SRAM card to the main memory.
1.
Install the card and then turn the unit on.
2.
First be sure your unit is unlocked and touch
TOOLS then select "Backup".
3.
Touch Backup to make a copy of the major
built-in application data onto the card. Note
that will delete ALL existing data on the card,
including any installed Add-on software
applications.
4.
Touch OK to confirm. Note the unit will take a
few seconds to re-start after this operation.
You can also copy the SRAM card data back into
the main memory by selecting Restore in step 3.
Note that using the Restore operation will delete
ALL existing data in the main memory including
any installed Add-on software applications.
To Next Page
Loading...
Need help?
General
