168
2.
If you want to remove a name from the
Recipient list, select the name and touch
REMOVE.
3.
Touch Done.
Touching a selected name on the Recipients list
displays the Send Status information as well as a date
(current date if the send status is Queued or the
transmission or failed transmission date otherwise) in
the area above the Address Book.
Messages stored in the SENT folder usually have the
“Sent” status.
Messages stored in the OUT folder have the “Queued”
status. The following is a list of errors for Send Status
information for messages stored in the OUT folder:
No Dial Tone The telephone line is not correctly
connected.
Line Busy TAP Access number is busy.
Line Error The line was cut off due to commu-
nication error.
No Pager PIN There is a problem in the PIN
Number number.
TAP Error There was a problem in the
communications protocol.
User aborted You pressed the ON key.
operation
Attaching data to a message
You can attach Appointment or To Do data to an
outgoing message. The data, however, must have been
filed into a FILER folder. Each message can accept only
one attachment. Follow the steps below to attach data
to a message.
1.
When you are composing a message, touch
ATTACH.
The following screen appears.
2.
Select the memory location, Main Unit or PC
Card, that contains the desired data.
To Next Page
Loading...
Need help?
General
