235
Problem
Solution
Alarms don't sound at
set times.
Enable alarms using
TOOLS/Sound, see p. 82.
Pressing a touch
button or touching the
display has no effect
(or an operation which
is not selected occurs).
A PC card is inserted
but it doesn't function.
Transferring a
Telephone or User File
entry (from an
Electronic Organizer)
results in the following
error message: "The
sending unit is
attempting to send
information in an
incompatible format.
This unit can't receive
this data."
Remove the card, and
then insert it again.
(Check from the back
of the unit that the card
is fully inserted.)
Press ON to access
the card functions. For
removing and inserting
cards, see p. 203.
Be sure that the
sending unit does not
have a blank (no
characters) Telephone/
Contact or User File/
Data File
field name
.
Calibrate the touch panel
using TOOLS/Display,
see p. 13.
C. Troubleshooting
When the unit is not functioning properly, refer to
the list below for solutions before contacting your
Sharp dealer.
Problem
Solution
The display remains
blank after pressing
ON.
• Make sure the battery
replacement switch is in
the NORMAL
OPERATION position.
• Adjust the LCD contrast,
see p. 12.
• Install new batteries,
see p. 236.
Poor display contrast.
Adjust the LCD contrast,
see p. 12.
The unit is turned on,
but pressing keys and
touch buttons has no
effect.
Reset the unit, see
p. 234.
"Not enough memory"
displayed.
The entire keyboard
including OFF does
not function.
The memory is full or
nearly full. Delete
unnecessary data or
install a RAM card.
Check the amount of free
memory using TOOLS/
Memory, see p. 81.
In Note, unlock the
keyboard by touching
KEYS at the top of the
display.
To Next Page
Loading...
Need help?
General
