119
Setting up connections
You can connect to CompuServe from different places
or via different networks, as follows:
1
. Make sure the unit is not connected to
CompuServe. From the Setup screen, touch
the Connection tab.
2
. Touch Add and enter a new connection
name. Then touch OK.
3
. Make any necessary changes to these
settings. See the “Connection settings”
section for details.
4
. Touch OK to save the changes.
Connection settings
Your name The name to identify yourself on CompuServe
User ID The ID required to access CompuServe
Password The password required to access CompuServe
The number of the access point to
CompuServe
Timeout The time to wait before hanging up the phone
Redial The number of times the unit should redial if it
Attempts cannot connect successfully. The acceptable
redial range is from 0 to 2. A value of 0 means
there will be no redial.
Network Use this pop-up menu to select a network to
access CompuServe.
Line Type Choose between tone or pulse dialing.
About the “On the road” connection
This is the default with the CIS 800#.
To remove a connection
While in the Connection tab, select a connection from
the Connection pop-up menu and touch Remove. When
prompted, touch Yes.
Phone
Number
To Next Page
Loading...
Need help?
General
