237
5.
Insert two new LR6(AA) operating batteries.
Align them correctly for positive (+) and
negative (-) polarity, as shown in the battery
well.
6.
Replace the operating battery cover.
7.
Set the battery replacement switch to the
"NORMAL OPERATION" position.
If nothing happens when you press ON:
• Setting the battery replacement switch to "RE-
PLACE BATTERIES" shuts off operating power.
Check that this switch is set to "NORMAL
OPERATION".
• Repeat the battery replacement procedure step
by step.
Replacing operating batteries
When using the unit, if BATT appears at the top of
the display, the operating batteries may need to be
replaced. To confirm this, turn the unit off and then
on again. The unit will display a message if the
operating batteries need to be replaced.
To replace the operating batteries:
1.
Turn the unit off.
2.
Set the battery replacement switch on the
back to "REPLACE BATTERIES" (the red dot
is visible).
3.
Slide the operating battery cover off.
1
2
4.
Remove the old operating batteries.
To Next Page
Loading...
Need help?
General
