213
To connect to the host:
1
. Touch MAIL, then select Send Only to send
messages in the OUT folder or Send/
Receive to send and receive messages
during the same session. Note that these
selections are available only if the currently
displayed folder is the OUT folder.
2
. Select the messages that you want to send
and touch OK. You can send one of the
following groups:
• Current Message: The one message that is
selected.
• Tagged Messages: The messages that are
tagged with the checkmark in the tag box.
• All Messages: Every message in the OUT folder.
3
. If you need to change the AT&T Mail or
Modem setup before connecting, touch
Setup.
4
. After verifying your modem and phone line
connection, touch OK to connect to AT&T
Mail.
The following display shows you the status of
the connection during this process. For a
successful connection, you see the following
messages:
• Configuring Modem
• Dialing the AT&T Mail Access phone number
• Logging into Host
• Completing communication link
To Next Page
Loading...
