5 | 188
17 Commissioning of control panel with AnalogPLUS detector line ............... 64
18 Changing and expanding the AnalogPLUS detector line .......................... 65
18.1 Adding a device to the detector line ...........................................................65
18.2 Replacing a device with one of a different type ...........................................65
18.3 Removing a device permanently ................................................................66
18.4 Replacing a non-stationary device of the same type ...................................66
18.5 Replacing multiple non-stationary devices of the same type
with a line restart........................................................................................66
18.6 Replacing stationary devices of the same type ...........................................67
18.7 Converting a stub or loop ...........................................................................67
18.8 Querying the number of devices on the detector line ..................................67
18.9 Readdressing devices................................................................................68
18.10 Replacing an AnalogPLUS device ..............................................................68
19 Commissioning of control panel with interactive detector line ................... 69
19.1 Commissioning of interactive detector line for AlgoRex data migration .......70
20 Changing and expanding the interactive detector line ............................. 71
20.1 Adding a device to the detector line ...........................................................71
20.2 Replacing a device with one of a different type ...........................................71
20.3 Removing a device permanently ................................................................72
20.4 Replacing a non-stationary device of the same type ...................................72
20.5 Replacing stationary devices of the same type ...........................................73
20.6 Replacing stationary manual call points of the same type ...........................73
20.7 Converting a stub or loop ...........................................................................74
20.8 Replacing an interactive device ..................................................................74
20.9 Locating wire breaks ..................................................................................75
21 Detailed commissioning steps .............................................................. 76
21.1 Preparing 'Station' for commissioning .........................................................76
21.2 Preparing 'Station' for commissioning –without BDV installation .................77
21.3 'One-step commissioning' ..........................................................................78
21.4 Auto-configuring 'Station' ...........................................................................79
21.5 Auto-configuring the detector line ...............................................................79
21.6 Loading automatically created configuration to the PC ...............................80
21.7 Adapting configuration ...............................................................................80
21.8 Converting a standalone station to a networked station ..............................81
21.9 Switch off ...................................................................................................82
21.9.1 Safety during switch-off ...............................................................82
21.9.2 Switching off the detector line ......................................................82
21.9.3 Switch off zone ...........................................................................82
21.10 Switching on ..............................................................................................83
21.10.1 Switch on detector line ................................................................83
21.10.2 Switch on zone ...........................................................................83
21.11 Restarting the detector line ........................................................................83
21.12 Freezing outputs ........................................................................................84
21.13 Enabling frozen outputs .............................................................................84
21.14 Read in devices on detector line ................................................................85
21.15 Detaching the device .................................................................................85
To Next Page
Loading...
