Siemens SCALANCE W1750D UI User Manual

Wireless Network Profiles
11.1 Configuring Wireless Network Profiles
SCALANCE W1750D UI
118 Configuration Manual, 02/2018, C79000-G8976-C451-02
3. Based on the type of client IP assignment mode selected, you can configure the VLAN
assignment for clients as described in the following table:
Client IP Assignment
Client VLAN Assignment
Virtual Controller assigned If
Virtual Controller assigned
is selected for client IP assignment,
the VC creates a private subnet and VLAN on the AP for the
wireless clients. The network address translation for all client
traffic that goes out of this interface is carried out at the source.
This setup eliminates the need for complex VLAN and IP ad-
dress management for a multisite wireless network.
On selecting this option, the following client VLAN assignment
options are displayed:
•
Default
—When selected, the default VLAN as determined by
the VC is assigned for clients.
•
Custom
—When selected, you can specify a custom VLAN
assignment option. You can select an existing DHCP scope
for client IP and VLAN assignment or you can create a new
DHCP scope by selecting
New
. For more information on
DHCP scopes, see Configuring DHCP Scopes on page 209.
Network assigned If
Network assigned
is selected, you can specify any of the fol-
lowing options for the
Client VLAN assignment
.
•
Default
—On selecting this option, the client obtains the IP
address in the same subnet as the APs. By default, the client
VLAN is assigned to the native VLAN on the wired network.
•
Static
—On selecting this option, you need to specify any one
of the following: a single VLAN, a comma separated list of
VLANS, or a range of VLANs for all clients on this network.
Select this option for configuring VLAN pooling.
•
Dynamic
—On selecting this option, you can assign the
VLANs dynamically from a Dynamic Host Configuration Pro-
tocol (DHCP) server. To create VLAN assignment rules, click
New
to assign the user to a VLAN. In the
New VLAN As-
signment Rule
window, enter the following information:
–
Attribute
—Select an attribute returned by the RADIUS
server during authentication.
–
Operator
—Select an operator for matching the string.
–
String
—Enter the string to match .
–
VLAN
—Enter the VLAN to be assigned.
4. Click
Next
to configure security settings for the Employee network. For more information,
see
Configuring Security Settings for a WLAN SSID Profile (Page 120).

Siemens SCALANCE W1750D UI Specifications

General

Brand	Siemens
Model	SCALANCE W1750D UI
Category	Wireless Access Point
Language	English