Siemens SCALANCE W1750D UI User Manual

Captive Portal for Guest Access
13.4 Configuring Internal Captive Portal for Guest Network
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
173
Parameter
Description
Uppercase support Set to
Enabled
to allow the AP to use uppercase letters in MAC
address string for MAC authentication.
NOTE:
This option is available only if MAC authentication is ena-
bled.
WISPr
(Applicable for WLAN SSIDs
only.)
Select
Enabled
if you want to enable WISPr authentication. For
more information on WISPr authentication, see Configuring WISPr
Authentication on page 173.
NOTE:
The WISPr authentication is applicable only for Internal-
Authenticated splash pages and is not applicable for wired pro-
files.
Auth server 1
Auth server 2
Select any one of the following:
• A server from the list of servers, if the server is already config-
ured.
•
Internal Server
to authenticate user credentials at run time.
• Select for configuring a new external RADIUS or LDAP server
for authentication.
Load balancing Select
Enabled
to enable load balancing if two authentication
servers are used.
Reauth interval Select a value to allow the APs to periodically reauthenticate all
associated and authenticated clients.
Blacklisting
(Applicable for WLAN SSIDs
only.)
If you are configuring a wireless network profile, select
Enabled
to
enable blacklisting of the clients with a specific number of authen-
tication failures.
Accounting mode
(Applicable for WLAN SSIDs
only)
Select an accounting mode from the
Accounting mode
drop-down
list for posting accounting information at the specified accounting
interval. When the accounting mode is set to
Authentication
, the
accounting starts only after client authentication is successful and
stops when the client logs out of the network. If the accounting
mode is set to
Association
, the accounting starts when the client
associates to the network successfully and stops when the client
is disconnected.
Accounting interval Configure an accounting interval in minutes within the range of 0–
60, to allow APs to periodically post accounting information to the
RADIUS server.
Encryption
(Applicable for WLAN SSIDs
only.)
Select
Enabled
to configure encryption parameters. Select an
encryption and configure a passphrase.

Siemens SCALANCE W1750D UI Specifications

General

Brand	Siemens
Model	SCALANCE W1750D UI
Category	Wireless Access Point
Language	English