Siemens SCALANCE W1750D UI User Manual

Monitoring Devices and Logs
32.1 Configuring SNMP
SCALANCE W1750D UI
484 Configuration Manual, 02/2018, C79000-G8976-C451-02
Name
----
SNMPv3 Users
------------
Name Authentication Type Encryption Type
---- ------------------- ---------------
SNMP Trap Hosts
---------------
IP Address Version Name Port Inform
Configuring SNMP Traps
SCALANCE W supports the configuration of external trap receivers. Only the AP acting as
the VC generates traps. The traps for AP cluster are generated with VC IP as the source IP,
if VC IP is configured. The Object Identifier (OID) of the traps is
1.3.6.1.4.1.14823.2.3.3.1.200.2.X.
You can configure SNMP traps by using the SCALANCE W UI or the CLI.
In the SCALANCE W UI
To configure a Syslog server and Syslog facility levels:
1. Navigate to
System > Show advanced options > Monitoring
2. Under
SNMP Traps
, enter a name in the
SNMP Engine ID
text box. It indicates the name
of the SNMP agent on the AP. The SNMPv3 agent has an engine ID that uniquely
identifies the agent in the device and is unique to that internal network.
3. Click New and update the following information:
–
IP Address
—Enter the
IP Address
of the new SNMP Trap receiver.
–
Version
—Select the SNMP version—
v1, v2c, v3
from the drop-down list. The version
specifies the format of traps generated by the access point.
–
Community/Username
—Specify the community string for SNMPv1 and SNMPv2c
traps and a username for SNMPv3 traps.
–
Port
—Enter the port to which the traps are sent. The default value is 162.
–
Inform
—When enabled, traps are sent as SNMP INFORM messages. It is applicable
to SNMPv3 only.
The default value is
Yes
.
4. Click
OK
to view the trap receiver information in the
SNMP Trap Receivers
window..

Siemens SCALANCE W1750D UI Specifications

General

Brand	Siemens
Model	SCALANCE W1750D UI
Category	Wireless Access Point
Language	English