Chapter 11 DME Operations
416
DME
The following table shows the interval between successive detents for each
transformation operation mode (see page 417).
a) When a value is smaller than 1, 1/Aspect or 1/Perspective (z) is adjusted to an integral value.
Three-dimensional parameter default values
Each of the transformation operation modes has default values for three-
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] (page 426) button in the device control block
twice in rapid succession.
The following table shows the default parameter values for each
transformation operation mode.
Resetting of parameter values set in the source coordinate space
In some transformation operation modes, if you switch to the target coordinate
space after setting up a three-dimensional transformation in the source
coordinate space, the setting values in the source coordinate space (three-
dimensional parameter values) are converted to values in the target coordinate
space (source/target conversion).
Once a conversion has taken place, the original source coordinate space
parameters do not return to their original values when you switch back to the
source coordinate space. They are reset to zeros.
Operation mode Detent interval
Location XYZ 1.0000
Rotation, Spin 0.2500
Axis Location 1.0000
Location Size 0.2500
Aspect
1.0000
a)
Perspective (x, y)
Perspective (z)
1.0000
1.0000
a)
Skew 0.1000
Operation mode Default value
Location XYZ 0.0000
Rotation, Spin 0.0000
Axis Location 0.0000
Location Size 1.0000
Aspect 1.0000
Perspective (x, y)
Perspective (z)
0.0000
1.0000
Skew 0.0000
To Next Page