Chapter 11 DME Operations
520
DME Special Effect Operations
To make the tip of the swirl stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
To set the center position of the swirl
1
Press [Position], turning it on.
2
Set the following parameters.
Melt settings
You can set the degree of transition, the degree of extension in the image, the
jaggedness of the melting sections, and the amplitude, frequency, amount of
movement, and speed of the melting sections. You can also set the slant of the
borders, the shape of the sections that begin to melt, and other parameters.
To apply the Melt effect
With the Melt menu displayed, use the following procedure.
1
In the <Direction> group, select the direction in which the image melts
away.
Up: Melting occurs upward.
Down: Melting occurs downward.
2
To make transition settings, press [Transition] and set the following
parameters.
2 Center Amount of rotation in center of swirl –8.000 to +8.000
3 Outer Amount of rotation outside of Area –8.000 to +8.000
4 Area Region of swirl 0.00 to 100.00
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Density Degree to which image
disappears
0.00 to 100.00
2 Random Trail type and amount of stardust 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 H Horizontal center position of swirl –8.000 to +8.000
2 V Vertical center position of swirl –6.000 to +6.000
To Next Page