ST STM32F2 User Manual

HAL DCMI Generic Driver
UM1940
188/1371
DocID028236 Rev 2
DCMI_EXTEND_DATA_10B
Interface captures 10-bit data on every pixel clock
DCMI_EXTEND_DATA_12B
Interface captures 12-bit data on every pixel clock
DCMI_EXTEND_DATA_14B
Interface captures 14-bit data on every pixel clock
DCMI Flags
DCMI_FLAG_HSYNC
HSYNC pin state (active line / synchronization between lines)
DCMI_FLAG_VSYNC
VSYNC pin state (active frame / synchronization between
frames)
DCMI_FLAG_FNE
FIFO not empty flag
DCMI_FLAG_FRAMERI
Frame capture complete interrupt flag
DCMI_FLAG_OVRRI
Overrun interrupt flag
DCMI_FLAG_ERRRI
Synchronization error interrupt flag
DCMI_FLAG_VSYNCRI
VSYNC interrupt flag
DCMI_FLAG_LINERI
Line interrupt flag
DCMI_FLAG_FRAMEMI
DCMI Frame capture complete masked interrupt status
DCMI_FLAG_OVRMI
DCMI Overrun masked interrupt status
DCMI_FLAG_ERRMI
DCMI Synchronization error masked interrupt status
DCMI_FLAG_VSYNCMI
DCMI VSYNC masked interrupt status
DCMI_FLAG_LINEMI
DCMI Line masked interrupt status
DCMI HSYNC Polarity
DCMI_HSPOLARITY_LOW
Horizontal synchronization active Low
DCMI_HSPOLARITY_HIGH
Horizontal synchronization active High
DCMI interrupt sources
DCMI_IT_FRAME
Capture complete interrupt
DCMI_IT_OVR
Overrun interrupt
DCMI_IT_ERR
Synchronization error interrupt
DCMI_IT_VSYNC
VSYNC interrupt
DCMI_IT_LINE
Line interrupt
DCMI MODE JPEG
DCMI_JPEG_DISABLE
Mode JPEG Disabled
DCMI_JPEG_ENABLE
Mode JPEG Enabled
DCMI PIXCK Polarity
DCMI_PCKPOLARITY_FALLING
Pixel clock active on Falling edge
DCMI_PCKPOLARITY_RISING
Pixel clock active on Rising edge
DCMI Synchronization Mode
DCMI_SYNCHRO_HARDWARE
Hardware synchronization data capture (frame/line
start/stop) is synchronized with the HSYNC/VSYNC
signals

ST STM32F2 Specifications

General

Brand	ST
Model	STM32F2
Category	Microcontrollers
Language	English