ST STM32F2

UM1940
HAL DCMI Generic Driver
DocID028236 Rev 2
187/1371
DCMI_IT_VSYNC: VSYNC interrupt
mask
DCMI_IT_LINE: Line interrupt mask
Return value:
None
__HAL_DCMI_DISABLE_IT
Description:
Disable the specified DCMI interrupts.
Parameters:
__HANDLE__: DCMI handle
__INTERRUPT__: specifies the DCMI
interrupt sources to be enabled. This
parameter can be any combination of the
following values:
DCMI_IT_FRAME: Frame capture
complete interrupt mask
DCMI_IT_OVR: Overrun interrupt
mask
DCMI_IT_ERR: Synchronization
error interrupt mask
DCMI_IT_VSYNC: VSYNC interrupt
mask
DCMI_IT_LINE: Line interrupt mask
Return value:
None
__HAL_DCMI_GET_IT_SOURCE
Description:
Check whether the specified DCMI
interrupt has occurred or not.
Parameters:
__HANDLE__: DCMI handle
__INTERRUPT__: specifies the DCMI
interrupt source to check. This parameter
can be one of the following values:
DCMI_IT_FRAME: Frame capture
complete interrupt mask
DCMI_IT_OVR: Overrun interrupt
mask
DCMI_IT_ERR: Synchronization
error interrupt mask
DCMI_IT_VSYNC: VSYNC interrupt
mask
DCMI_IT_LINE: Line interrupt mask
Return value:
The: state of INTERRUPT.
DCMI Extended Data Mode
DCMI_EXTEND_DATA_8B
Interface captures 8-bit data on every pixel clock