ST STM32F2 - Page 665

UM1940
HAL UART Generic Driver
DocID028236 Rev 2
665/1371
peripheral.
Return value:
None
UART_IT_MASK
Description:
Enable the specified UART interrupt.
Parameters:
__HANDLE__: specifies the UART
Handle. This parameter can be
UARTx where x: 1, 2, 3, 4, 5, 6, 7 or
8 to select the USART or UART
peripheral.
__INTERRUPT__: specifies the
UART interrupt source to enable.
This parameter can be one of the
following values:
UART_IT_CTS: CTS change
interrupt
UART_IT_LBD: LIN Break
detection interrupt
UART_IT_TXE: Transmit Data
Register empty interrupt
UART_IT_TC: Transmission
complete interrupt
UART_IT_RXNE: Receive Data
register not empty interrupt
UART_IT_IDLE: Idle line
detection interrupt
UART_IT_PE: Parity Error
interrupt
UART_IT_ERR: Error
interrupt(Frame error, noise
error, overrun error)
Return value:
None
__HAL_UART_ENABLE_IT
__HAL_UART_DISABLE_IT
Description:
Disable the specified UART
interrupt.
Parameters:
__HANDLE__: specifies the UART
Handle. This parameter can be
UARTx where x: 1, 2, 3, 4, 5, 6, 7 or
8 to select the USART or UART
peripheral.
__INTERRUPT__: specifies the
UART interrupt source to disable.
This parameter can be one of the
following values: