5 Operation
Lifting
DANGER
Reaching into or climbing between moving parts
of the truck (e.g. lift mast, sideshifts, working
equipment, load carrying devices etc.) can lead to
serious injury or death and is therefore prohibited.
– Observe the safety regulations for handling
loads.
– Only operate the lifting system from the driver’s
seat.
Hydraulic blocking function
The hydraulic blocking function ensures that
all hydraulic functions are disabled whenever
the seat switch in the driver’s seat is unloaded
This is when the driver stands up from the
driver’s seat or exits the truck. All hydraulic
functions are disabled in this case:
• Lift the load
• Lower the load
• Tilt the lift mast
• Auxiliary hydraulic functions
To ensure that the hydraulics blocking function
does not lock as well, the operating device
must be in the neutral position for the "Lifting"
function.
Enabling the hydraulic blocking function
The hydraulic blocking function must be
enabled after the following incidents:
• The driver has stood up from the driver’s
seat whilst lowering the load.
• The driver has left the driver’s seat for more
than one minute.
Proceed as follows to enable the hydraulic
blocking function:
– Sit down on the driver’s seat.
– Lift the fork a little.
13
2 55048011501 EN - 12/2015
To Next Page
Loading...
