5 Operation
Checks and operations prior to comm
issioning
5051_460-004
1
– Check tyres (1) for wear or damage.
Tyres must not be damaged or excessively
worn. They must be worn evenly on both
sides.
NOTE
Observe the safety regulations in the chapter
entitled "Tyres".
Adjusting the GS15 driver’s seat
DANGER
There is a risk of accident if the seat or seat backrest
shifts suddenly, which could cause the driver to
move in an uncontrolled manner. This may result in
unintentional actuation of the steering or operating
devices and thus cause the truck or load to move in
an uncontrolled fashion.
– Do not adjust the seat or seat backrest while
driving.
– Adjust the seat and the seat backrest so that all
operating devices can be actuated safely
– Ensure that the seat and seat backrest are
securely engaged.
WARNING
On some equipment variants, the
amount of head clearance on the
truck may be restricted.
On these specific equipment va-
riants, the distance between the head
and the lower edge of the roofing
sheet must be at least 40 mm.
NOTE
If there are separate operating instructions for
the seat, they must be followed.
72
55048011501 EN - 12/2015