Operation 5
Malfunctions
LOWER FORKS message
DANGER
There is a risk to life caused by a falling load or if
parts of the truck are being lowered!
Parking the truck with the load lifted is dangerous
and is not permitted under any circumstances! The
increased safety provided by this function may not
be misused in order to take safety risks.
– Before leaving the truck, lower the load fully.
7312_003-071_en_V2
Theforkisnotlowered.
If the fork is above the height sensor, the key
switch is turned off and the seat vacated,
the
LOWER FORKS message appears in
the display (variant). An optional signal tone
sounds.
– Lower the forks to the ground.
The message
LOWER FORKS disappears.
7312_003-072_en_V3
REFERENCE CYCLE message
If the fork was lowered after the truck was
switched off, the control electronics do not
know the position of the fork when the truck
is restarted. The truck will only travel at a
reduced driving speed. Depending on the
position of the fork, the message
REFERENCE
CYCLE
(variant) may appear in the display. To
align the position with the control electronics,
the fork must be raised.
– Switch on the key switch.
The truck will only travel at a reduced driving
speed. The message
REFERENCE CYCLE
may appear in the display.
– Raise the fork
55
048011501 EN - 12/2015 235
To Next Page
Loading...
