Operation 5
Commissioning
Switching on the key switch
WARNING
Before switching on the key switch, all tests prior to
start-up must be performed without detecting any
defects.
– Perform the tests prior to commissioning.
– Do not operate the truck if defects have been
detected.
– Notify the authorised service centre.
NOTE
If the truck is switched on with the steering
wheel turned, the maximum driving speed
is limited. The driving speed limitation is
disabled as soon as the truck is steered out of
cornering to drive in a straight line. A change
in steering angle of around half a revolution is
sufficient for this to be the case.
I
1
0
5060_003-029_V2
– Insert switch key (1) into the key switch and
turn to position "I".
55
048011501 EN - 12/2015 83
To Next Page
Loading...
