5 Operation
Handling the battery
If the truck does not have a battery bridge or an
internal roller channel as optional devices for
the battery installation or battery replacement,
these activities must be carried out by the
STILL service centre.
CAUTION
Possible risk of injury or risk of damage to compo-
nents.
To install or remove the battery, do not disassemble
the available battery lock.
Maintaining the battery
DANGER
Risk to life!
– Observe the chapter "Safety regulations for
handling the battery".
WARNING
Battery acid is toxic and corrosive!
– Observe the safety regulations in the "Battery
acid" chapter.
NOTE
Battery maintenance is carried out in accor-
dance with the battery manufacturer’s opera-
ting instructions! The operating instructions
for the battery charger must also be followed.
Only the instructions that came with the battery
charger are valid. If any of these instructions
are not available, please request them from
the dealer.
Depending on the equipment, the battery can
also be removed for maintenance. This must
only be carried out using the specified devices;
see section "Lifting accessory" in the chapter
"Safety regulations for handling the battery".
27
8 55048011501 EN - 12/2015
To Next Page
Loading...
