Operation 5
Operation in special operating sit
uations
– Screw the eye bolt into the stowed position.
CAUTION
The cables can be damaged by being crushed —
there is risk of short circuit!
Cables must not be crushed when screwing in the
eye bolt.
– Ensure that the wiring can move freely.
– Close the battery hood again.
Crane loading
Crane loading is only intended for transporting
the complete truck, including the lift mast,
for its initial commissioning. For application
conditions that require frequent loading or that
are not presented here, please contact the
manufacturer with regard to special variants.
Only those persons with sufficient experience
of suitable harnesses and hoists may load
trucks.
Type-Modèle-Typ / Serial no.-No. de série-Serien-Nr. / year-année-Baujahr
Rated capacity
Capacité nominale
Nenn-Tragfähigkeit
Battery voltage
Tension batterie
Batteriespannung
Rated drive power
Puissance motr.nom.
Nenn-Antriebsleist.
Unladen mass
Masse à vide
Leergewicht
max
min.*
* see Operating instructions
voir Mode d'emploi
siehe Betriebsanleitung
kg
kg
kg
kg
kg
kW
V
*
1
3
2
6210_001-016_V2
Determining the actual total weight
– Park the truck securely; see ⇒ Chap-
ter "Parking the truck securely and switch-
ing it off", P. 5-282.
– Determine the unit weights by reading the
truck nameplate and, if necessary, the
attachment (variant) nameplate.
– Add the determined unit weights to obtain
the actual total weight of the truck:
Tare weight (1)
+
Max. permissible battery weight (2)
+
Ballast weight (variant) (3)
+
Attachment net weight (variant)
=
Actual total weight
.
55
048011501 EN - 12/2015 243
To Next Page
Loading...
