2 Introduction
Residual risk
Overview of hazards and counter-
measures
NOTE
This table is intended to help evaluate the
hazards in your facility and applies to all drive
types. It does not claim to be complete.
– Observe the national regulations for the
country in which the truck is being used.
Hazard Measure
Check note
√ Complete
- Not applicable
Notes
Truck equipment does
not comply with local
regulations
Test
O If in doubt, consult
competent factory
inspectorate or
employers’ liability
insurance association
Lack of skills and
qualification of driver
Driver training (sit-on
and stand-on)
O BGG 925
VDI 3313 driver permit
Usage by unautho-
rised persons
Access with key only
for authorised persons
O
Truck not in a safe
condition
Recurrent testing and
rectification of defects
O German Ordinance on
Industrial Safety and
Health (BetrSichV)
Risk of falling when
using working
platforms
Compliance with
national regulations
(different national
laws)
O German Ordinance on
Industrial Safety and
Health (BetrSichV)
and employer’s
liability insurance
associations
Impaired visibility due
to load
Resource planning
O German Ordinance on
Industrial Safety and
Health (BetrSichV)
Assessment of diesel
exhaust gases
O
Technical Regulations
for Hazardous
Substances (TRGS)
554 and the German
Ordinance on
Industrial Safety and
Health (BetrSichV)
Contamination of
respiratory air
Assessment of LPG
exhaust gases
O German threshold
limit values list
(MAK-Liste) and the
German Ordinance on
Industrial Safety and
Health (BetrSichV)
20
55048011501 EN - 12/2015
To Next Page
Loading...
