6 Maintenance
Providing access to maintenance po
ints
Providing access to maintenance points
Removing/installing the valve cover
Removing the valve cover
NOTE
A 4-mm hexagon socket wrench (2) is located
between the battery hood (1) and valve cover
(5) to assist in carrying out the following work.
This hexagon socket wrench must remain in
the truck at all times.
In the single-pedal version:
– Remove the right bottom plate (4) ⇒ Chap-
ter "Removing/installing the bottom
plate", P. 6-311.
In the dual-pedal version:
3
5
1
2
3
4
5060_003-049_V2
– Remove the right bottom plate (4) ⇒ Chap-
ter "Removing/installing the bottom plate for
dual pedal operation (variant)", P. 6-313.
– Unscrew the four screws (3).
– Lift up the valve cover (5) and remove.
Installing the valve cover
– Position the valve cover and attach it with
four screws.
– Install the right bottom plate.
– Return the hexagon socket wrench to its
position between the battery hood and valve
cover.
31
0 55048011501 EN - 12/2015
To Next Page
Loading...
