3 Safety
Essentials for safe operation
Changes to the overhead guard and
roof loads
DANGER
In the event of the overhead guard failing due to
a falling load or the truck tipping over, there are
potentially fatal consequences for the driver. There
is a risk to life!
Welding and drilling on the overhead guard chan-
ges the material characteristics and the structural
design of the overhead guard. Excessive forces
caused by falling loads or the truck tipping over may
result in buckling of the modified overhead guard
andnoprotectionforthedriver.
– Do not perform welding on the overhead guard.
– Do not perform drilling on the overhead guard.
CAUTION
Heavy roof loads damage the overhead guard!
To ensure the stability of the overhead guard at
all times, a roof load may only be mounted on the
overhead guard if the structural design has been
tested and the manufacturer has given approval.
– Seek advice from the authorised service centre
for the mounting of roof loads.
Warning regarding non-original parts
Original parts, attachments and accessories
are specially designed for this truck. We
specifically draw your attention to the fact that
parts, attachments and accessories supplied
by other companies have not been tested and
approved by STILL.
CAUTION
Installation and/or use of such products may there-
fore have a negative impact on the design features
of the truck and thus impair active and/or passive
driving safety.
We recommend that you obtain approval from the
manufacturer and, if necessary, from the relevant
regulatory authorities before installing such parts.
The manufacturer accepts no liability for any da-
mage caused by the use of non-original parts and
accessories without approval.
32
55048011501 EN - 12/2015
To Next Page
Loading...
