Operation 5
Handling the battery
6210_003-012
1
2
Battery transport with crane
DANGER
If the load is dropped, the conse-
quences could potentially be fatal!
– Never walk or stand underneath
suspended loads.
– Ensure there is sufficient distance between
the truck and any obstacles so that the truck
is not damaged when the crane is used.
To avoid short circuits, batteries with open
terminals or connectors should be covered
with a rubber mat.
– Attach battery (1) to suitable lifting gear (2).
Observe the operating instructions for the
lifting gear.
The lifting gear should be vertical when lifting,
so that no lateral pressure is applied to the
tray.
– Lift the battery from the roller channel.
Ensure that there is sufficient distance from
the battery door.
– Set the battery down carefully.
– Do not place or allow slack lifting gear to fall
on the battery cells.
55
048011501 EN - 12/2015 269
To Next Page
Loading...
