5 Operation
Decommissioning
5060_003-169
2
1
1
Wheel chock (variant)
The wheel chock (variant) is used to prevent
the truck from rolling away on a slope.
NOTE
Due to the design, the sec
urely parked truck
can only be chocked at the
rear wheel. The
truck must be parked faci
ng uphill on slopes
where a wheel chock is to b
e used.
– Lift the handle (2) on the support mounting.
– Remove the wheel chock (1) from the
support mounting.
– Slide the wheel chock un
derneath the back
wheel on the side facing
downhill.
NOTE
After use, return the wheel chock to the
support mounting and press the handle (2)
down again.
Shutting down and storing the truck
CAUTION
Component damage due to incorrect storage!
In the event of incorrect storage or shutdown for
more than two months, the truck may suffer corro-
sion damage. If the truck is parked in an ambient
temperature of below –10 °C for an extended pe-
riod, the batteries cool down. The electrolyte may
freeze and damage the batteries.
– Store the truck in a dry, clean, frost-free and well
ventilated environment.
– Carry out the following measures before shut-
down.
Measures before shutdown
– Clean the truck thoroughly; see chapter
"Cleaning".
– Lift fork carriage to stop several times.
– Tilt the lift mast forwards and backwards
several times and, if fitted, move attachment
repeatedly.
28
4 55048011501 EN - 12/2015
To Next Page
Loading...
