EasyManua.ls Logo

Still RX50-13 - Driving on Ascending and Descending Slopes; Driving on Lifts

Still RX50-13
374 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 Operation
Working with loads
6210_001-008
Driving on ascending and descend-
ing slopes
DANGER
Danger to life!
On ascending and descending slopes the load must
be carried facing uphill.
It is only permitted to drive on ascending and
descending slopes if they are marked as traffic
routes and can be used safely.
The driver must check that the ground is clean with
a good grip.
It is not permitted to perform turns on ascending
slopes, to approach them diagonally or to park the
truck on them.
Drive at a reduced speed on descending slopes.
It is not permitted to put items into stock or to
remove them from stock while on an ascending
or descending slope.
Theforklifttruckshouldnotbeparkedonaslope.
In case of emergency, secure the truck with
chocks.
5060_003-071
Driving on lifts
The driver is only allowed to use this truck
on lifts with a sufficient load capacity and for
which the operating company (see Chap-
ter "Definition of responsible persons", P. 26)
has been granted authorisation.
DANGER
There is a risk to life from being crushed or run over
by the truck.
There must be no personnel already in the lift
when the truck is driven into the lift.
Personnel are only permitted to enter the lift once
the truck is secure, and must exit the lift before
the truck is driven out.
16
2 55048011501 EN - 12/2015

Table of Contents

Related product manuals