5 Operation
Lifting
Overriding and reactivating the auto-
matic lift cut out
If a load needs to be lifted to the truck’s
maximum lift height and the automatic lift
cut out function is not required, it is possible
to override the lift cut out. It is automatically
reactivated when the truck is switched off and
back on again.
To override the automatic li
ft cut out:
F1
1
7312_003-160_V3
– Press the "F1"(1) button on the display
operating unit. The automatic lift cut out is
now overridden and a load can be lifted to
the truck’s maximum lift height.
To switch the automatic lift cut out back on:
– Press the "F1"(1) button a
gain.
Lift mast vertic
al position (variant)
Description
If the truck is equipped with the "lift mast
vertical position" comfort feature (variant),
the driver can put down goods, such as paper
rolls, vertically with precision and thus avoid
damage when unloading. The tilt cylinders
run into the end stops gently to prevent hard
vibrations and impacts. Oscillating motions of
the truck are minimised, thus increasing work
safety. The lift mast vertical position reduces
wear on various components and therefore
reduces maintenance costs.
12
4 55048011501 EN - 12/2015
To Next Page
Loading...
