Operation 5
Working with loads
1
6210_842-001
Adjusting the fork
– Lift the locking lever (1) and move the fork
arms to the desired position.
– Allow the locking lever to snap
back into
place.
The load centre of gravity must be midway
between the fork arms.
– Only actuate the fork prong positioner
(variant) when the fork is not carrying a
load.
Danger area
The danger area is the area in which people
are at risk due to the movements of the truck,
its working equipment, its load-carrying
equipment (e.g. attachments) or the load.
Also included are the areas where loads
could fall or working equipment could fall or
be lowered.
DANGER
Risk of injury!
– Do not step on the fork.
DANGER
Risk of injury!
– Do not step under the raised forks.
DANGER
People may be injured in the danger area of the
truck!
The danger area of the truck must be completely
clear of all personnel, except the driver in his
normal operating position. If persons fail to leave
the danger area despite warnings:
– Cease work with the truck immediately.
– Secure the truck against use by unauthorised
parties.
55
048011501 EN - 12/2015 153
To Next Page
Loading...
