Operation 5
Handling the battery
NOTE
If the truck is fitted with the ER
S or HRS
driver restraint system (vari
ant), the following
measures must be observed for o
pening and
closing the battery hood.
Preparations for ERS drive
r restraint
system (variant)
CAUTION
Risk of component damage!
If you remove the battery male connector while
the key switch is switched on (under load), an arc
will be produced. This can lead to corrosion at the
contacts, which considerably shortens their service
life.
– Switch off the key switch before the battery male
connector is disconnected.
– Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
– Disconnect the battery male connector;
see the chapter entitled "Disconnecting the
battery male connector".
– Pull release button (4).
frs_003-021
4
5
– Swivel restraining brackets (5) downwards.
55
048011501 EN - 12/2015 255
To Next Page
Loading...
