Maintenance 6
Maintenance
Checking the seat belt
6327_342-009
1
2
3
– Pull out the belt (3) completely and check
for wear.
The belt must not be frayed or cu
t. The
stitching must not be loose.
– Check whether the belt is dirty.
– Check whether parts are worn or damaged,
including the attachment points.
– Check the buckle (1) to ensu
re that it locks
into place properly.
When the belt tongue (2) is inserted, the belt
must be held securely.
7090_342-005
1
4
– The belt tongue (2) must release when the
red button (4) is pressed.
– The automatic bloc
king mechanism must
be tested at least
once a year:
– Park the forklift truck on level ground.
– Pull out the belt with a jerk.
The automatic blo
cking mechanism must
block extension o
fthebelt.
– Tilt the seat at least 30°. In order to do
this, open the battery hood fully, see
⇒ Chapter "Opening and closing the battery
hood", P. 5-254.
– Slowly extend the belt.
The automatic b
locking mechanism must
block extensio
nofthebelt.
Cleaning the s
eat belt
– Clean the seat belt as necessary, but
without using chemical cleaning materials
(a brush will suffice).
Replacement after an accident
As a rule, the seat belt must be replaced after
an accident.
55
048011501 EN - 12/2015 317
To Next Page
Loading...
