Universal Robots E Series Original Instructions

•
Line allows you to write a single line of URscript code, using the Expression Editor (23.3.
Expression Editoron page145)
•
File allows you to write, edit or load URscript files.
You can find instructions for writing URscript in the Script Manual on the support website
(http://www.universal-robots.com/support).
Functions and variables declared in a URscript file are available for use througout the program in
the PolyScope.
23.12.6. Event
An event can be used to monitor an input signal, and perform some action or set a variable when
that input signal goes high. For example, in the event that an output signal goes high, the event
program can wait for 200ms and then set it back to low again. This can make the main program
code a lot simpler in the case on an external machine triggering on a rising flank rather than a high
input level. Events are checked once every control cycle (2ms) .
UR5e 174 User Manual
23.Program Tab
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.

Universal Robots E Series Specifications

General

Brand	Universal Robots
Model	E Series
Category	Robotics
Language	English