4.Transportation
As supplied on the pallet, the robot and Control Box are a calibrated set. Do not separate them as
this would require recalibration.
Only transport the robot in its original packaging. Save the packaging material in a dry place if you
want to move the robot later.
When moving the robot from its packaging to the installation space, hold both tubes of the robot
arm at the same time. Hold the robot in place until all mounting bolts are securely tightened at the
base of the robot.
Lift the Control Box by its handle.
WARNING
1. Make sure not to overload your back or other bodyparts when lifting the
equipment. Use proper lifting equipment. All regional and national lifting
guidelines shall be followed. Universal Robots cannot be held responsible for
any damage caused by transportation of the equipment.
2. Make sure to mount the robot according to the instructions in
chapter5.Mechanical Interface on page27.
User Manual 25 UR5e
4.Transportation
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
