29.4. System
29.4.1. Backup and Restore
Save a full copy of your system to a USB drive and use it to restore your system back to a previous
state. This may be necessary after disk corruption or accidental deletion.
NOTE
Use one of the USB ports inside the Control Box (CB) when doing a Backup and
Restore operation. Using a CB USB port is more stable and running a Backup
requires less time.
Backing up the System
1. In the Header, tap the Hamburger menu icon and select Settings.
2. Under System, tap Backup Restore.
3. Select Location to store the back-up and press Backup.
4. Tap OK for full system reboot.
Restoring the System
NOTE
If you restore a system with a new SD card, you must match the Serial Number in
the new SD card image when you start up Polyscope. Failure to match the Serial
Number can result in an incomplete restore process. A g restore error appears for
not finding the matching serial number
1. In the Header, tap the Hamburger menu icon and select Settings.
2. Under System, tap Backup Restore.
3. Select your Backup file and press Restore.
4. Tap OK to confirm.
29.4.2. Update
Install updates from a USB to ensure the robot software is up-to-date.
User Manual 261 UR5e
29.Hamburger menu
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
