It is declared that the above products, for what is supplied, fulfill the following Directives as
detailed below:
Reference the harmonized
standards used,
referred to in Article 7(2) of
the MD and LV Directives
and Article 6 of the EMC
Directive
(I) EN ISO 10218-1:2011 TUV Nord Cert. 4470814097607
(I) EN ISO 13849-1:2015 TUV Nord Cert. 4420714097610
(I) EN ISO 13732-1:2008, (I) EN 1037:1995+A1:2008
(I) EN ISO 13849-2:2012, (I) EN ISO 13850:2015
(II) EN 60204-1:2006/A1:2010, (II) EN 60320-1:2001/A1:2007
(II) EN 60529:1991/A2:2013, (II) EN 60947-5-5:1997/A11:2013
(III) EN 61000-6-2:2005, (III) EN 61000-6-4:2007/A1:2011
Reference to other technical
standards
and specifications used
(I) ISO/TS 15066 as applicable
(II) IEC 60664-1:2007, (II) IEC 60664-5:2007, (II) IEC 61326-3-
1:2008
(II) IEC 61784-3:2010 (SIL2) ISO 14664-1:2015 (Cleanroom
Class 6 for control assembly with enclosure and Class 5 for
UR3e, UR5e,UR10e and UR16e manipulators)
(III) IEC 60068-2-1:2007, (III) IEC 60068-2-2:2007
(III) IEC 60068-2-27:2008, (III) IEC 60068-2-64:2008
The manufacturer, or his authorized representative, shall transmit relevant information about the
partly completed machinery in response to a reasoned request by the national authorities.
Approval of full quality assurance system (ISO 9001), by the notified body Bureau Veritas,
certificate #DK008850.
User Manual 69 UR5e
12.Declarations and Certificates
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
