Predelivery check
10-6
PTT unit
Check the PTT unit operation. 10-21
Check that there is no abnormal noise produced when the out-
board motor is tilted up or down.
Abnormal noise Ch
eck the PTT unit.
9-24
Steer the tilted-up outboard motor.
Interference Ch
eck the hose and wire harness routing, or
mounting of the outboard motor.
2-26
5-1
1-1
Check that the trim meter on the boat’s gauge displays full down
when th
e outboard motor is in the full-down position.
Full down not displayed Adjust the tr
im sensor cam.
9-30
Steering system
Check that the steering operates smoothly.
Not smooth Chec
k the upper case, steering arm, and swivel
bracket, or related parts.
9-14
9-16
9-21
9-28
Steer the outboard motor.
Interference Ch
eck the hose and wire harness routing.
2-26
5-1
Shift cable/throttle
cab
le
Check the shift cable when the remote control lever or gear shift
le
ver is moved to the N position.
Not at the proper position Adjust
the shift cable joints or check
the related parts.
3-5
Check the throttle cable when the remote control lever is moved to
the N po
sition (remote control model).
Check the throttle cable when the throttle grip is turned to the fully
closed
position (tiller handle model).
Not at the proper position Adjust
the throttle cable joint or
check the related parts.
3-6
6-22
Te s t r u n
Start the engine, and then check that the gear shift operates
smoothly
.
—
Warm up the engine, and then check the engine idle speed.
Out of specification P
erform the troubleshooting procedures.
—
Operate the boat at trolling speed. —
Operate the outboard motor according to the break-in procedure. —
Check that the outboard motor does not tilt up when reverse oper-
ation.
Tilts up Chec
k the PTT unit.
9-24
Check that the power trim operates smoothly while cruising.
Not smooth Chec
k the PTT if the power trim operates.
9-24
Item Procedures See
To Next Page
