11-5
IM DLM4038-02EN
Searching Waveforms
Setting Search Conditions (Condition Setup)
Note
Using the CH8 Terminal and LOGIC(L) Port
When you execute a search, you cannot use the CH8 terminal and LOGIC(L) port as the source at the same
time. Specify the source that you want to use in advance by pressing either the CH8 key or the L key.
Press the Condition Setup soft key to display one of the menus shown below. The menu that is
displayed varies depending on the specified source.
Set the source
(CH1 to CH8, Math1 to Math4).
Set the qualifications.
Set the logic combination (AND, OR).
Set the search requirement (True, False).
Set the hysteresis and the level used to
detect the state for each signal.
Set the slope ( , ).
When the Source is CH1 to CH8 or Math1 to Math4
When the Source Is LOGIC(L) or LOGIC(A|B)*
Set the source (LOGIC(L),
LOGIC(A|B)).
Set the source bit (L0 to L7,
A0 to A7, B0 to B7).*
* LOGIC(A|B), A0 to A7, and B0 to B7 are available on models with the /L16 option.
Setting the Qualifications (Qualification)
Press the Qualification soft key to display the following screen.
Example: When the source is CH1
Set the qualifications (H, L, X)
for signals other than the
source.
/L16 option
Signal set to be the source
CH8 and L0 to L7 cannot
be enabled
simultaneously.
Specify the source that
you want to use in
advance by pressing
either the CH8 key or the
L key.
11.2 Using Conditions to Limit Edge Searches
To Next Page
Loading...
