14-3
IM DLM4038-02EN
14.2 Analyzing Switching Loss
Note
• If you set the power supply analysis type to SW Loss, automated measurement of waveform parameters
is enabled. The measured values from the measurement items set on the MEASURE menu, and the
switching loss measurement items are displayed on the screen.
A maximum of 30 measurement items can be displayed. If measured switching loss values are not
displayed, reduce the number of MEASURE menu measurement items.
►section9.1
• If you turn Power(Math1) or Power(Math2) on, the power trace is displayed on the screen. If you then
press MATH/REF key, the following menu is displayed.
Operation is fixed to Power.
Source is fixed to the channel specified on the Probe Setup menu.
If you turn Power(Math1) or Power(Math2) off, the normal computation setup menu is displayed when you
press MATH/REF.
To Next Page
Loading...
Need help?
General
