14-3
IM DL950-02EN
Setting the Judgment Conditions (Judgement Setup)
2.
Tap Judgement Setup, or press the soft key. The following screen appears.
Set the judgment criterion (X, IN, OUT).
Select the source waveform (CH1 to CH16, Math1 to Math8, FFT1 to FFT8).
Set the zone number (Zone1-Zone6).
Set the determination logic (AND, OR).
Set the action condition (Always, Fail, Success).
Set the sequence (Single, Continue).
Set the number of waveforms to acquire.
Turns external start on or off
Scroll bar
Scroll to display reference conditions that do not fit in
the screen.
Determination Logic (Logic)
AND: The specified action is executed when all the specified judgment conditions are met.
OR: The specified action is executed when any of the specified judgment conditions is met.
Action Condition (Act Condition)
Always: The specified actions is always executed.
Fail: The specified action is executed when the GO conditions are not met.
Success: The specified actions is executed when the GO conditions are met.
Sequence (Sequence)
Single: The specified action is executed once.
Continue: The specified action is executed repeatedly. The specified action is executed until
the number of acquisitions specified by ACQ Count is reached. If ACQ Count is
set to Infinite, the set actions are executed until waveform acquisition is stopped.
14.1 Performing GO/NO-GO Determination with Waveform Zones
To Next Page
Loading...
Need help?
General
