YOKOGAWA ScopeCorder DL950 User Manual

2-14
IM DL950-02EN
All Sub Channel Setup (All Sub Channel Setup)
3.
Tap All Sub Channel Setup, or press the soft key. An All Sub Channel Setup screen appears.
4.
Tap Setup, or press the soft key.
When measuring voltage, set the input coupling to DC or GND.
Scope Mode
Set the zoom magnification.
Vertical position
Vertical scale or temperature unit
Set the zoom offset.
Vertical scale
Input coupling
Display label
To set all the sub
channels to the same
setting, change the
settings in the All row.
Slide to display channels
that do not fit in the screen.
The displayed items vary
depending on the input
coupling and vertical
scale settings of the
selected sub channel.
See “Setting the Linear
Scaling.”
See “Copying
Channels.”
When the vertical scale is set to SPAN, the settings for
Offset, Position, V and Zoom change to Upper and Lower.
Scroll bar
Recorder Mode
Upper limit of display range
Slide to display channels
that do not fit in the screen.
Measurement range
Input coupling
Display label
To set all the sub
channels to the same
setting, change the
settings in the All row.
The displayed items vary
depending on the input
coupling settings of the
selected sub channel.
See “Setting the Linear
Scaling.”
See “Copying
Channels.”
Lower limit of display range
Scroll bar
Note
You cannot turn on and off the waveform input at the sub channel level.
2.2 Configuring Voltage Measurements (on 16-CH temperature/voltage input modules)

YOKOGAWA ScopeCorder DL950 Specifications

General

Brand	YOKOGAWA
Model	ScopeCorder DL950
Category	Test Equipment
Language	English