2-21
IM DL950-02EN
All Sub Channel Setup (All Sub Channel Setup)
3.
Tap All Sub Channel Setup, or press the soft key. An All Sub Channel Setup screen appears.
Turns RJC on or off
Set the lower limit.
Unit (°C, K)
Set the upper limit.
Thermocouple type
Set input coupling to TC.
Display label
To set all the sub
channels to the same
setting, change the
settings in the All row.
Slide to display channels
that do not fit in the screen.
The displayed items vary
depending on the input
coupling and vertical
scale settings of the
selected sub channel.
Sub channels of
temperature measurement
are not applicable.
See “Copying
Channels.”
Turns burnout on or off
Copying Channels (Copy to)
4.
Tap Copy to, or press the soft key. The following screen appears.
Press to select all sub channels.
Press to clear all sub channels.
Select the sub channels that
you want to copy to.
Starts copying
Select the source sub channel.
The setup and linear scale settings are copied.
2.4 Configuring Temperature Measurements (For 16-CH temperature/voltage input modules)
To Next Page
Loading...
