2-29
IM DL950-02EN
Channel Setup Menu
1.
On the waveform screen’s MENU, tap VERTICAL > CH, or press CH. A channel setup menu
appears.
(You can also tap the channel information display area at the top of the screen to display the
channel setup menu.)
2.
Tap a channel you want to configure, or select it using the jog dial or up and down arrow keys.
Scope Mode
Turns the waveform
input on or off
Channel setup menu (1/2)
Channel setup menu (2/2)
See “Setting
Measurement Items.”
See “Setting Input
Conditions.”
Set the display label.
Set the linear scaling.
► sec. 2.1
Set the bandwidth limit and
digital filter. ► sec 2.1.
Display settings
► sec. 2.1
Set the sample rate.
► sec. 2.1
Set the display range.
► sec. 2.1
Recorder Mode
Turns the waveform
input on or off
Channel setup menu (1/2)
Channel setup menu (2/2)
See “Setting
Measurement Items.”
See “Setting Input
Conditions.”
Set the display label.
Set the linear scaling.
► sec. 2.1
Set the bandwidth limit and
digital filter. ► sec 2.1.
Display settings
► sec. 2.1
Set the sample interval.
► sec. 2.1
Set the display range.
► sec. 2.1
2.7 Configuring Frequency, Revolution, Period, Duty Cycle, Power Supply Frequency, Pulse Width, Pulse
Integration, and Velocity Measurements
To Next Page
Loading...
