302 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Procedures: Ribbon Take-up Assembly
Replacement
Replacement is performed by reversing the removal steps.
Tests and Adjustments
After replacing the ribbon takeup assembly, you will need to perform the ZMotif Service Partner Tool
Ribbon Torque Calibration procedure.
Note • The ZMotif Service Partner Tool only works through a USB connection to the printer.
This procedure requires the Torque Adjustment Tool 105936-46 (also part of the ZXP9 Repair
Kit 105936-058). The kit consists of a low-torque xture and a high-torque xture; both xtures
should be calibrated once a day using the calibration turn table and each calibrated value should be
printed on its associated xture. Contact Zebra Customer Service at +01 877-275-9327 for ordering
information.
Step 1. Launch the ZMotif Service Partner Tool.
Step 2. From the Printer Type menu, select ZXP Series 9.
To Next Page
Loading...