P1086708-001 ZXP Series 9 Card Printer Service Manual 409
Replacement Procedures for the Laminator
Procedures: Laminator Beam
Step 2. Attach the laminator to the printer:
a. Set the Printer on its right side.
b. While supporting the printer, slide the support attachment beam and laminator
into the slot (dashed arrow above) on the left side of the printer.
c. Align the four mounting holes on the printer (arrows above) with the four
mounting holes on the support attachment beam.
d. Using four machine screws, attach the laminator (via the support attachment
beam) to the printer.
e. Check the t and alignment of the laminator to the printer.
To Next Page
Loading...