Commonly Used Procedures 6
Agilent Nano Indenter G200 User’s Guide 6-22
Figure 6-31Retrieve Batch File dialog box
3 Select the batch file to load.
4 Click Open.
The batch may have more samples than you want to run.
5 Delete any samples that you do not want to run:
a Click on any sample within the batch.
b Right-click on that highlighted sample.
c Select Delete once the desired sample is highlighted for removal.
6 Click Run Batch to begin the test.
NanoSuite will prompt you to edit the names of each sample in the batch
via the Review Sample Names dialog box as shown in
Figure 6-32 on
page 6-23.
To Next Page
Loading...
