ASTRO VG Series User Manual

198
<I/F Check mode setting parameters>
The following functions are available in I/F Check mode.
Page Number key Item Description
7
LT
Link training is performed each time this key is pressed.
This switches the Hotplug status.
Detect The current connected status is judged.
8
Hotplug
Negate The Hotplug status is forcibly set to the Negate status. (*1).
9
PW SAVE
This makes the power save mode setting for the connected component.
4
VID_MUTE
This sets Video MUTE to On or Off. (*2)
5
AUD_MUTE
This sets Audio MUTE to On or Off. (*2)
1/2
0
EDIT
This enters the DisplayPort output setting menu.
7
DEFAULT
This returns to the currently selected program pattern.
8
LIST
This displays the DisplayPort display screen GUI (refer to “4.12.3 Displaying
the DisplayPort setting information”).
9
EDID
This reads the EDID of the connected component. This is the same operation
as the normal EDID Read operation.
2/2
0
EDIT
This enters the DisplayPort output setting menu.
When Page 1 is displayed, the following Hotplug statuses are shown.
Item Description
Port This displays the port to be used by the “DisplayPort Analysis” set by the device settings.
HPD Mode This displays the HPD mode set by the DisplayPort output settings.
This displays the Hotplug status.
ASSERT Hotplug is asserted.
NEGATE Hotplug is negated.
Status
- - HPD mode is OFF. (The Hotplug status is not judged.)
*1 Concerning the Hotplug Negate setting
The Hotplug signal is used by the sink component to notify its status to the source component. This function
performs processing to forcibly set the Negate status (cable disconnected status) on the
VG-870B/871B/873/874 side.
This function can be used to check sink component operation with respect to the initial operation of the source
component (the VG-870B/871B/873/874), without disconnecting and connecting the cable.
*2 Concerning the VID_MUTE and AUD_MUTE settings
The VID_MUTE setting is active only for the “Port” which was selected as the Configuration setting.
The AUD_MUTE setting is set for both Port 1 and Port 2.
*3 The first page of the DisplayPort display screen GUI (refer to “4.12.3 Displaying the DisplayPort setting
information”) is shown when link training is restarted, such as when the LT key is pressed, the Hotplug
detection is performed again, or operation recovers from power save mode, etc.

ASTRO VG Series Specifications

General

Brand	ASTRO
Model	VG Series
Category	Portable Generator
Language	English