Version 6.6 143 Mediant 2000
User's Manual 12. Security
Parameter Name Description
a DPD message to query the status of the peer. If the device has
no traffic to send, it never sends a DPD message.
Remote Tunnel Addr
[IPsecSATable_RemoteT
unnelAddress]
Defines the IP address of the peer router.
Note: This parameter is applicable only if the Operational Mode is set
to Tunnel.
Remote Subnet Addr
[IPsecSATable_RemoteS
ubnetIPAddress]
Defines the IP address of the remote subnet. Together with the Prefix
Length parameter (below), this parameter defines the network with
which the IPSec tunnel allows communication.
Note: This parameter is applicable only if the Operational Mode is set
to Tunnel.
Remote Prefix Length
[IPsecSATable_RemoteS
ubnetPrefixLength]
Defines the prefix length of the Remote Subnet IP Address parameter
(in bits). The prefix length defines the subnet class of the remote
network. A prefix length of 16 corresponds to a Class B subnet
(255.255.0.0); a prefix length of 24 corresponds to a Class C subnet
(255.255.255.0).
Note: This parameter is applicable only if the Operational Mode is set
to Tunnel.
Interface Name
[IPsecSATable_Interface
Name]
Assigns a network interface to this IPSec rule. The network interfaces
are defined in the Multiple Interface table ('Interface Name' column) in
'Configuring IP Network Interfaces' on page 106
To Next Page
Loading...
Need help?
General
